Good Work Today

I decided to make my own sensor/controller so I came up with this idea, I do not know if it works or not so don't duplicate this until I test it. Basically it is a 4x4x4 junction box, ($10.00 at Home Depot). I wanted a curved lens so I cut a piece of my acrylic and placed it in the oven at 250 degrees for about 10 min. The sides were supported but not in the middle. It bowed in the middle like you see in the photo. It was super easy and worked fine.

I traced the radius of my bowed acrylic and cut it out on my bandsaw. I was careful to leave some screw contact boss in each corner.

Hey what do you know, that looks pretty good and best of all it is plastic and will not ground out the sensor as recommended by Duane at Redrok.

I used some rigid foam to secure the sensor in the cover, works great. Be sure to orient the sensor as Duane describes. I also drilled 2 small holes in the bottom of the sensor for condensation drainage, here in Louisiana we have no shortage of humidity. I hope it works

Just a photo to show where I am with the install on this date.
KACO 1502xi Inverter Installed per code in my shop.

Nice and clean install with the wires fed from the back of the inverter so that no wiring will be seen (once the wall is sheetrocked.)

I wanted a clean mount and I utilized the posterior mounting holes in the inverter. Nice and clean.

Just a view of the wiring fed through the ground to the panels.

Doing what I do the best! Dig with a shovel.

Today I was off work and was able to accomplish a lot of the installation of the grid tie solar tracker. Check out the photo's especially the sensor cover that I made. I think it is pretty cool, I have no idea if it works or not yet.